TrainCarts/Signs/Launcher/ja

概要

LauncherサインはStationサインと似ており、列車を発車させたり、任意の速度に変更したりできます。加減速する距離や発車させる方向なども指定可能です。速度ゼロで発車させると、Stationサインで列車が停止するような感じで、徐々に止まります。なお、これは速度が固定されるわけではないので、列車を押し出したりパッと止めることは可能です。

記法

[train]

launch 10

0.4

continue

一行目

[cart]と[train]を使うことでの挙動の差はありません。遠隔操作を利用することもできます。

Second line

launch or launcher, followed up by the launch configuration. Launching can be done over a set distance, a set time, or at a constant acceleration. The launch function can be configured as linear or bezier. A bezier curve will accelerate slower towards the beginning and end of the launch.

Syntax	Meaning
launch	Automatically computes a suitable distance to launch at, by looking for the first bend in the rails up ahead. The maximum distance calculated this way is 100 blocks.
launch 20.0	Launches the train to the target speed over 20 blocks (meters)
launch 20.0s	Launches the train to the target speed in 20 seconds
launch 1m	Launches the train to the target speed in 1 minute
launch 500ms	Launches the train to the target speed in 500 milliseconds
launch 100t	Launches the train to the target speed in 100 ticks (5 seconds)
launch 2.2G	Launches the train to the target speed at a constant acceleration based on a G-force of 2.2 (0.2406m/t2)
launch 10km/h/s	Launches the train to the target speed at a constant acceleration. See the TrainCarts/Acceleration page for more information. Must have a slash somewhere to be considered an acceleration expression.
launch 20l launch 20sl launch 10km/h/sl	By appending a l at the end of the expression, the launch follows a linear curve.
launch 20b launch 20sb launch 10km/h/sb	By appending a b at the end of the expression, the launch follows a bezier curve.

Third line

The speed to launch at. If left empty, it will launch at the speed specified in the configuration (launchForce). To put the train to a complete halt, use 0.

Absolute speeds use a positive or zero number with no sign; to launch the train to a speed of 1.25 blocks per tick (25 blocks per second, or 90 km/h), use "1.25". Relative speeds require a sign even when positive; to launch the train to a speed 0.5 higher than it was before, write "+0.5"; to decrease the speed by 0.5, write "-0.5".

When only a value is specified, the unit is blocks/tick. For all other supported units, see TrainCarts/Velocity

Speed limit

Normally trains will never speed up beyond what the speed limit property is set to. To overcome this, you will need to set a new speed limit, but setting the speed limit property may result in an instant speed-up. To fix this, it is possible to specify two numbers on the launcher sign to update both. It will smoothly launch to a new speed limit speed, and set the remainder as 'energy' that will slowly go down.

Speed limit syntax

Set a new speed limit of 2.0 and launch the train to this speed over a distance of 20 blocks. Once reached, give the train 10 'energy'.

[train]

launch 20

2.0 10.0

Fourth line

Optionally you can specify the direction to launch here. The default parameter, if blank, is "continue" – it will launch the train in the same direction from which it came.