//Station
介紹
車站用於停止和啟動列車，可設置停止時間（以秒為單位）。車站會將紅石信號輸入的方向作為列車的啟動方向，當兩邊都有紅石信號輸入時，車站會自動設置列車的啟動方向。
語法
第一行
使用 [train] 時，列車的中心位置（比如列車中間的礦車）會停在車站牌的上方。當使用 [cart] 時，列車會立即停止，第一輛礦車會停在車站牌的上方。
第二行
Station，後可跟數值。這個數值表示列車的啟動距離。數值越高，啟動速度就越慢。不加數值則插件會自動計算啟動距離，此時會將列車啟動到最遠 100 格方塊內的第一個彎軌道上。
你還可以指定「中心偏移量」，用於改變列車停靠車站的位置。通過指定 <距離數值>m 來修改，例如 「20.5m」。
下面的車站將會啟動列車到30格方塊外，且列車停靠車站時列車中心相對於車站牌偏移12.5格方塊。列車將等待10秒，然後啟動：
第三行
可選的停止時間（以秒為單位）。停止時間應用於啟動時。例如，當紅石從右側激活車站牌且車站牌設置了 3 秒停止時間時，當有列車駛入時，列車將等待 3 秒，之後朝右側（紅石信號輸入方向）駛出。
Fourth line
Sets the mode used when both sides are powered. The station sign will launch trains into the direction that is powered. If the sign receives no power whatsoever, it is not active and trains will travel right through. The inverted redstone option ([!train]) is still active here, so if power is inverted and the sign receives no power, it is as if all sides a powered.
The station will hold the train forever if both sides are powered, unless one of the below four types is set on the fourth line:
| Sign | Result |
|---|---|
| |
| |
| |
|
Auto Routing
Instead of specifying a fixed direction, route can be put instead. This will make the station sign part of the path finding network, and launches the train into the most appropriate direction to reach its destination.
This will route the train to its destination, if set. Otherwise, resumes the train in the same direction it was approaching the station.
Launch Speed
A number can also be put on the fourth line to set the launch speed of the station sign.
Lever Output
While a train is waiting on the station, the station toggles levers attached to the same block the station sign is attached to. This can be used to, for example, change the player exit property, open doors or automatically eject the players inside.
Lever is toggled while a train waits on a station
Alternative setup with a wall sign
Station output is used to automatically enable/disable players entering and exiting the train
Examples
Shuttle-run
