TrainCarts/Signs/Station/en - Revision history

TC Bot: Updating to match new version of source page

2025-11-25T04:45:15Z

Updating to match new version of source page

← Older revision		Revision as of 04:45, 25 November 2025
Line 40:		Line 40:
	! scope="col" \| Result		! scope="col" \| Result
	\|-		\|-
	\| [~~[File:Sign~~ 1~~.png~~\|~~thumb]]~~		\| {{sign\|[train]\|station 5\|1\|left}}
	\| [[Image:TrainCarts station left.gif\|Image:TrainCarts station left.gif]]		\| [[Image:TrainCarts station left.gif\|Image:TrainCarts station left.gif]]
	\|-		\|-
	\| [~~[File:Sign 2.png~~\|~~thumb]]~~		\| {{sign\|[train]\|station 5\|1\|right}}
	\| [[Image:TrainCarts station right.gif\|Image:TrainCarts station right.gif]]		\| [[Image:TrainCarts station right.gif\|Image:TrainCarts station right.gif]]
	\|-		\|-
	\| [~~[File:Sign 3.png~~\|~~thumb]]~~		\| {{sign\|[train]\|station 5\|1\|continue}}
	\| [[Image:TrainCarts station continue.gif\|Image:TrainCarts station continue.gif]]		\| [[Image:TrainCarts station continue.gif\|Image:TrainCarts station continue.gif]]
	\|-		\|-
	\| [~~[File:Sign 4.png~~\|~~thumb]]~~		\| {{sign\|[train]\|station 5\|1\|reverse}}
	\| [[Image:TrainCarts station reverse.gif\|Image:TrainCarts station reverse.gif]]		\| [[Image:TrainCarts station reverse.gif\|Image:TrainCarts station reverse.gif]]
	\|}		\|}

TC Bot: Updating to match new version of source page

2025-10-12T09:43:18Z

Updating to match new version of source page

← Older revision		Revision as of 09:43, 12 October 2025
Line 1:		Line 1:
	<languages/>		<languages/>
	~~[[Special:MyLanguage/TrainCarts/Signs\|« Go back]]~~


	== Introduction ==		== Introduction ==

TC Bot: Updating to match new version of source page

2024-09-23T15:19:35Z

Updating to match new version of source page

← Older revision		Revision as of 15:19, 23 September 2024
Line 57:		Line 57:

	==== Auto Routing ====		==== Auto Routing ====
	Instead of specifying a fixed direction, <code>route</code> can be put instead. This will make the station sign part of the [[TrainCarts/PathFinding\|path finding network]], and launches the train into the most appropriate direction to reach its destination.		Instead of specifying a fixed direction, <code>route</code> can be put instead. This will make the station sign part of the [[Special:MyLanguage/TrainCarts/PathFinding\|path finding network]], and launches the train into the most appropriate direction to reach its destination.

	This will route the train to its destination, if set. Otherwise, resumes the train in the same direction it was approaching the station.		This will route the train to its destination, if set. Otherwise, resumes the train in the same direction it was approaching the station.
Line 71:		Line 71:

	== Lever Output ==		== Lever Output ==
	While a train is waiting on the station, the station toggles levers attached to the same block the station sign is attached to. This can be used to, for example, change the [[TrainCarts/Signs/Property\|player exit property]], open doors or [[TrainCarts/Signs/Ejector\|automatically eject]] the players inside.		While a train is waiting on the station, the station toggles levers attached to the same block the station sign is attached to. This can be used to, for example, change the [[Special:MyLanguage/TrainCarts/Signs/Property\|player exit property]], open doors or [[Special:MyLanguage/TrainCarts/Signs/Ejector\|automatically eject]] the players inside.

	<gallery widths=300px heights=250px>		<gallery widths=300px heights=250px>

TC Bot: Updating to match new version of source page

2022-12-03T18:34:48Z

Updating to match new version of source page

← Older revision		Revision as of 18:34, 3 December 2022
Line 22:		Line 22:
	''Station'' followed up by an optional number. This number sets the distance to launch the trains at. The higher this number, the slower it will launch. Use only ''station'' to make the plugin calculate this distance automatically. Then it launches the train towards the first curved track piece up to 100 blocks away.		''Station'' followed up by an optional number. This number sets the distance to launch the trains at. The higher this number, the slower it will launch. Use only ''station'' to make the plugin calculate this distance automatically. Then it launches the train towards the first curved track piece up to 100 blocks away.

			You can also specify a 'center offset' value, which changes where the train will stop on the station. This is done by specifying '''<distance>m''', for example ''''20.5m''''.

			The below station sign will launch a train 30 blocks away, and center the train with a 12.5 block offset above the sign. The train waits for 10 seconds and then continues:
			{{sign\|[+train]\|station 30 12.5m\|10\|continue}}

	=== Third line ===		=== Third line ===

TC Bot: Updating to match new version of source page

2022-08-20T20:58:10Z

Updating to match new version of source page

← Older revision		Revision as of 20:58, 20 August 2022
Line 31:		Line 31:
	=== Fourth line ===		=== Fourth line ===

	Sets the mode used when both sides are powered. The station sign will launch trains into the direction that is powered. If the sign receives no power whatsoever, it is not active and trains will travel right through. The inverted redstone option ([!train]) is still active here, so if power is inverted and the sign receives no power, it is as if all sides a powered.		Sets the mode used when both sides are powered. The station sign will launch trains into the direction that is powered. If the sign receives no power whatsoever, it is not active and trains will travel right through. The inverted redstone option ([!train]) is still active here, so if power is inverted and the sign receives no power, it is as if all sides a powered.

	The station will hold the train forever if both sides are powered, unless one of the below four types is set on the fourth line:		The station will hold the train forever if both sides are powered, unless one of the below four types is set on the fourth line:
Line 51:		Line 51:
	\| [[Image:TrainCarts station reverse.gif\|Image:TrainCarts station reverse.gif]]		\| [[Image:TrainCarts station reverse.gif\|Image:TrainCarts station reverse.gif]]
	\|}		\|}

			==== Auto Routing ====
			Instead of specifying a fixed direction, <code>route</code> can be put instead. This will make the station sign part of the [[TrainCarts/PathFinding\|path finding network]], and launches the train into the most appropriate direction to reach its destination.

			This will route the train to its destination, if set. Otherwise, resumes the train in the same direction it was approaching the station.
			{{sign\|[train]\|station\|\|route continue}}


	==== Launch Speed ====		==== Launch Speed ====

TC Bot: Updating to match new version of source page

2022-08-18T16:18:36Z

Updating to match new version of source page

← Older revision		Revision as of 16:18, 18 August 2022
Line 58:		Line 58:

	{{sign\|[train]\|station\|5\|continue 0.4}}		{{sign\|[train]\|station\|5\|continue 0.4}}

			== Lever Output ==
			While a train is waiting on the station, the station toggles levers attached to the same block the station sign is attached to. This can be used to, for example, change the [[TrainCarts/Signs/Property\|player exit property]], open doors or [[TrainCarts/Signs/Ejector\|automatically eject]] the players inside.

			<gallery widths=300px heights=250px>
			File:Tc_station_lever_one.png\|Lever is toggled while a train waits on a station\|alt=alt language
			File:Tc_station_lever_two.png\|Alternative setup with a wall sign\|alt=alt language
			File:Tc_station_enterexit.png\|Station output is used to automatically enable/disable players entering and exiting the train
			</gallery>

	== Examples ==		== Examples ==


	=== Shuttle-run ===		=== Shuttle-run ===

	[[File:TrainCarts-Shuttle-run.gif\|File:TrainCarts-Shuttle-run.gif]]		[[File:TrainCarts-Shuttle-run.gif\|File:TrainCarts-Shuttle-run.gif]]

TC Bot: Updating to match new version of source page

2022-08-06T12:55:33Z

Updating to match new version of source page

← Older revision		Revision as of 12:55, 6 August 2022
Line 5:		Line 5:
	== Introduction ==		== Introduction ==

	[[~~Special:MyLanguage/Image~~:TrainCarts station centred.png\|thumb\|A train is idling above a station sign]]		[[File:TrainCarts station centred.png\|thumb\|A train is idling above a station sign]]
	Stations are used to stop and launch trains, optionally using a set delay in seconds. It can use redstone to set the direction to launch to, but when both sides are powered it can perform an automated action.		Stations are used to stop and launch trains, optionally using a set delay in seconds. It can use redstone to set the direction to launch to, but when both sides are powered it can perform an automated action.


	== Syntax ==		== Syntax ==
Line 53:		Line 52:
	\|}		\|}

			==== Launch Speed ====
			A number can also be put on the fourth line to set the launch speed of the station sign.
			{{sign\|[train]\|station\|\|0.4}}


			{{sign\|[train]\|station\|5\|continue 0.4}}

	== Examples ==		== Examples ==

TC Bot: Updating to match new version of source page

2021-02-08T17:34:10Z

Updating to match new version of source page

New page

<languages/>
[[Special:MyLanguage/TrainCarts/Signs|« Go back]]

== Introduction ==

[[Special:MyLanguage/Image:TrainCarts station centred.png|thumb|A train is idling above a station sign]]
Stations are used to stop and launch trains, optionally using a set delay in seconds. It can use redstone to set the direction to launch to, but when both sides are powered it can perform an automated action.

== Syntax ==

{{sign|[train]|station|5|continue}}

=== First line ===

When ''[train]'' is used, the train is centered above the sign. This means that the middle cart of the train will stop above the sign. When ''[cart]'' is used, the train will stop immediately, the first cart centered above the sign.

=== Second line ===

''Station'' followed up by an optional number. This number sets the distance to launch the trains at. The higher this number, the slower it will launch. Use only ''station'' to make the plugin calculate this distance automatically. Then it launches the train towards the first curved track piece up to 100 blocks away.

=== Third line ===

'''
An optional delay in seconds. This delay is used when launching. For example, when the right side is powered and a delay of 3 seconds is set, and a train enters, the train will wait for 3 seconds and then launch into the powered direction.'''

=== Fourth line ===

Sets the mode used when both sides are powered. The station sign will launch trains into the direction that is powered. If the sign receives no power whatsoever, it is not active and trains will travel right through. The inverted redstone option ([!train]) is still active here, so if power is inverted and the sign receives no power, it is as if all sides a powered.

The station will hold the train forever if both sides are powered, unless one of the below four types is set on the fourth line:
{| class="wikitable"
|-
! scope="col" | Sign
! scope="col" | Result
|-
| [[File:Sign 1.png|thumb]]
| [[Image:TrainCarts station left.gif|Image:TrainCarts station left.gif]]
|-
| [[File:Sign 2.png|thumb]]
| [[Image:TrainCarts station right.gif|Image:TrainCarts station right.gif]]
|-
| [[File:Sign 3.png|thumb]]
| [[Image:TrainCarts station continue.gif|Image:TrainCarts station continue.gif]]
|-
| [[File:Sign 4.png|thumb]]
| [[Image:TrainCarts station reverse.gif|Image:TrainCarts station reverse.gif]]
|}

== Examples ==

=== Shuttle-run ===

[[File:TrainCarts-Shuttle-run.gif|File:TrainCarts-Shuttle-run.gif]]